No products in the cart.
Component, Electronic Parts
TP4056 SOP-8 Lithium Battery Charging IC 1A
Availability:
Out of stock
TP4056 SOP-8 Lithium Battery Charging IC 1A
1,100 Ks
Out of stock
TP4056 SOP-8 Lithium Battery Charging IC 1A
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
- Electronic Parts, Module
DS3231 RTC Module
out of stock- Weight: 8g
- Operating voltage :3.3 – 5 .5 V
- Clock chip: high-precision clock chip DS3231
- Clock Accuracy :0-40 ℃ range, the accuracy 2ppm, the error was about 1 minute
- Calendar alarm clock with two
- Programmable square-wave output
- Real time clock generator seconds, minutes, hours, day, date, month and year timing and provide valid until the year 2100 leap year compensation
- Chip temperature sensor comes with an accuracy of ± 3 ℃
- Memory chips: AT24C32 (storage capacity 32K)
- I2C bus interface, the maximum transmission speed of 400KHz (working voltage of 5V)
SKU: EAP-000006 - Electronic Parts, Module, OLED Display Module
0.96 OLED Display Module (128×64) (Blue)
out of stock- Work perfectly well without the need of back light.
- 128*64 high resolution, ultra wide viewing angle
- Super low power consumption–only 0.08W when the whole screen lights up and 0.06W when displaying characters
- Fully compatible with multiple controlling chips including Arduino and more.
- Support a wide range of voltage input
SKU: EAP-000019 - Electronic Parts, Module, Relay Module
1 Channel Relay Module (5V,10A)
52 in stock- 1 channel relay board
- Operating Voltage 5V
- Max Current : 20mA
- Relay Contact Current Capacity at AC250V: 10A
- Relay Contact Current Capacity at DC5V: 10A
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for avoidance of malfunction
- Power supply indicator lamp
- Control indicator lamp
- Indicator for Relay output status
- Can Be controlled various appliances & other Equipment With Large current.
- Standard TTL Level logic controlled (AVR, Arduino, 8051, PIC, ARM)
- The module is compliant with international safety standards, control and load areas isolation trenches.
SKU: EAP-000013 - Electronic Parts, Module, Detection & Sensor Module
HTU21D Temperature and Humidity Sensor Module
In StockElectronic Parts, Module, Detection & Sensor ModuleHTU21D Temperature and Humidity Sensor Module
22 in stock- ​Uses the I2C interface
- Typical humidity accuracy of ±2%
- Typical temperature accuracy of ±0.3C
- Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain)
- 3.3V sensor – use inline logic level converters or 10k resistors to limit 5V signals
- Only one HTU21D sensor can reside on the I2C bus at a time
SKU: EAP-000002
There are no reviews yet.