-
×
HCSR04 Ultrasonic Sensor Module
1 × 4,400 Ks
Subtotal: 4,400 Ks
Battery, Component, Electronic Parts
SONY SR626SW Cell Battery(1.55V) x (1Pcs)
Availability:
Out of stock
- Battery Voltage:Â 1.55V
- Battery Chemistry:Â Silver Oxide
- Battery Size:Â 377 SR626SW
- Battery Capacity:Â 28mAh
5,100 Ks
Out of stock
Sony SR626SW 377 28mAh 1.55V Silver Oxide Watch Battery.
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Related products
-
Electronic Parts, Module, OLED Display Module
0.91 OLED Display Module (Blue)
4 in stock- 0.91 inch I2C/IIC 128×32 OLED Display Module
- Work perfectly well without the need of back light.
- 128*32 high resolution, ultra wide viewing angle
- The display is self-illuminating
- Power requirement is low
- Fully compatible with multiple controlling chips including Arduino and more.
- Better performance characteristics than traditional LCD and LED displays.
SKU: EAP-000020 -
Electronic Parts, Development Board, ESPRESSIF(ESP)
ESP32-Cam Development Board
18 in stock- Ultra-small 802.11b/g/n Wi-Fi + BT/BLE SoC module
- Low-power dual-core 32-bit CPU for application processors
- Up to 240MHz, up to 600 DMIPS
- Built-in 520 KB SRAM, external 4M PSRAM
- Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC
- Support OV2640 and OV7670 cameras with built-in flash
- Support for images WiFI upload
- Support TF card
- Support multiple sleep modes
- Embedded Lwip and FreeRTOS
- Support STA/AP/STA+AP working mode
- Support Smart Config/AirKiss One-click distribution network
- Support for serial local upgrade and remote firmware upgrade (FOTA)
SKU: EAP-000024 -
Electronic Parts, Module, Detection & Sensor Module
HTU21D Temperature and Humidity Sensor Module
In StockElectronic Parts, Module, Detection & Sensor ModuleHTU21D Temperature and Humidity Sensor Module
22 in stock- ​Uses the I2C interface
- Typical humidity accuracy of ±2%
- Typical temperature accuracy of ±0.3C
- Operates from 0 to 100% humidity but this sensor isn’t recommended for harsh environments where it could come in contact with water (such as rain)
- 3.3V sensor – use inline logic level converters or 10k resistors to limit 5V signals
- Only one HTU21D sensor can reside on the I2C bus at a time
SKU: EAP-000002 -
Electronic Parts, Module, Relay Module
8 Channel Relay Module (5V,10A)
27 in stockDC or AC signal, control, you can control the 220V AC load;
There is a normally open and one normally close contact;
The module is compliant with international safety standards, control and load areas isolation trenches.SKU: EAP-000010
There are no reviews yet.