Hakko HU-200 Auto Soldering System 230V

Easy-to-operate 4-axis + 1 (feeder) control soldering robot system
All-in-one soldering robot system into which the solder feed controller and the programming software are incorporated. All operations such as soldering conditions including solder feed amount and heating time can be controlled collectively by the tablet PC provided as standard equipment.

Time-reduced programming work and excellent operability
Collecting control from soldering conditions to robot control with the tablet PC provided as standard equipment which allows you to set all items, such as programming and soldering conditions, by the touch-panel operation on the same panel without connecting a teaching pendant or a PC.

Pre-installed Easy Programming Software
An easy programming software (Easy Programming Software II) is preinstalled, which allows you to create a soldering program easily without expert knowledge about robots. This software also allows you to control the number of accumulated soldering points and work time. Thus, only setting the tip replacement timing allows the robot to undergo automatic stop.

Easy teaching by EPS (Easy Positioning System)
Teaching can be made intuitively using the joystick, and speed and inching pitch can be easily changed. When performing delicate position adjustment, setting the mode to inching pitch allows you to operate the robot as finely as 0.01 mm unit at minimum. Using the EIS (Easy Input Switch) allows you to input the coordinates of robot and feed steps automatically, which can reduce the teaching time.

Convenient work origin and palletizing functions to shorten the teaching time
In the case of teaching with multiple P.W.B.s arranged, programming is possible only by inputting the offset value from the original position. Soldering positions arranged at the same interval in the case of connectors, etc. and can be soldered by inputting the movement distance and number of soldering sessions after positioning at one section.

Prevents malfunctions by reading 2D codes
Reading the barcode and QR code attached on a P.W.B. using a barcode reader allows you to select operation channels automatically. This prevents malfunctions by human error.
*A barcode reader is optional.

Useful functions to stabilize the soldering quality
A feeder with solder balls and flux splash-prevention function provided as standard equipment. Cutting a V-groove on solder surface can prevent solder balls and flux from splashing.

A brush-type cleaner provided as standard equipment
This brush type cleaner can remove not only residual solder but also carbide generated from burned flux.

Quick and easy tip replacement by the tip position adjustment jig
If more handpieces are prepared, another soldering tip can be mounted on the spare handpiece during operation of the robot.

Soldering quality and workability increased remarkably with 300 W high power
Using 300 W high power can improve the conventional failures “non-soldering due to insufficient heating” and “insufficient solder rising on through-hole back side”. Work requiring long heating time can be shortened drastically. In the case of fine work, the tip for 140 W can be also used.

40 types of TX2 series soldering tip are lined up
40 types of TX2 series soldering tip are lined up for a wide range of soldering conditions. The use of appropriate tip can not only improve quality and efficiency of soldering but also reduce running costs.